Additions:
**#12.** Spread dish soap into the trim groove.
**#13.** Spread dish soap on the windshield trim barb.
**#14.** Install the window trim to the new seal.
**#15.** Install clothesline into the body/seal mounting lip groove with four - five inch overlap in the Bottom Center of glass seal, leave several feet of extra cord out beyond the overlap for hand pulling...
**#16.** pull the headliner over the upper lip seal area, and glue in place with trim adhesive.
**#17.** Gently lift the glass/seal/trim assembly.
**#18.** Insert the lower glass seal over the body lip, and gently lean the assembly against the window area.
**#19.** At least two assistants must gently press down and in on the glass while you pull the cords out evenly.
**#20.** The seal lip should roll open as the cord pulls out = allowing the seal to seat to the body.
**#21.** Use instrument cluster hooks to seat the outer perimeter of the seal.
**#22.** gently press/thump any trim areas not fully seated.
**#23.** Install the rear windshield defogger connections middle of left and right C pillar.
**#24.** Install the right and left rear paneling with cut-out for safety belt.
**#13.** Spread dish soap on the windshield trim barb.
**#14.** Install the window trim to the new seal.
**#15.** Install clothesline into the body/seal mounting lip groove with four - five inch overlap in the Bottom Center of glass seal, leave several feet of extra cord out beyond the overlap for hand pulling...
**#16.** pull the headliner over the upper lip seal area, and glue in place with trim adhesive.
**#17.** Gently lift the glass/seal/trim assembly.
**#18.** Insert the lower glass seal over the body lip, and gently lean the assembly against the window area.
**#19.** At least two assistants must gently press down and in on the glass while you pull the cords out evenly.
**#20.** The seal lip should roll open as the cord pulls out = allowing the seal to seat to the body.
**#21.** Use instrument cluster hooks to seat the outer perimeter of the seal.
**#22.** gently press/thump any trim areas not fully seated.
**#23.** Install the rear windshield defogger connections middle of left and right C pillar.
**#24.** Install the right and left rear paneling with cut-out for safety belt.
Deletions:
**#12.** Spread dish soap on the windshield trim barb.
**#13.** Install the window trim to the new seal.
**#14.** Install clothesline into the body/seal mounting lip groove with four - five inch overlap in the Bottom Center of glass seal, leave several feet of extra cord out beyond the overlap for hand pulling...
**#15.** pull the headliner over the upper lip seal area, and glue in place with trim adhesive.
**#16.** Gently lift the glass/seal/trim assembly.
**#17.** Insert the lower glass seal over the body lip, and gently lean the assembly against the window area.
**#18.** At least two assistants must gently press down and in on the glass while you pull the cords out evenly.
**#19.** The seal lip should roll open as the cord pulls out = allowing the seal to seat to the body.
**#20.** Use instrument cluster hooks to seat the outer perimeter of the seal.
**#21.** gently press/thump any trim areas not fully seated.
**#22.** Install the rear windshield defogger connections middle of left and right C pillar.
**#23.** Install the right and left rear paneling with cut-out for safety belt.
